There are some necessary codes in the processing of metal stamping, and we must comply with, so since it is very important, then below, the editor to spend some time to this aspect of the content of the specific explanation, so that you can clearly understand to learn, understand and grasp, so as to be able to better understand sheet metal processing, and in-depth into this field, so that their knowledge is more, more knowledge.

    Some of the codes in sheet metal are applicable, mainly the thickness of the material to be cut, the basic size should be 0.5-6 mm, and the maximum width range, should be 2500 mm.

    1. Material

    (1) The material used should be in line with the technical requirements of the conditions, otherwise it can not be used.

    (2) If the use of cold-rolled steel, then its surface is not allowed to have abrasions, scratches, rust and impurities, etc., that is, the requirements are not defective.

    (3) equipment to be ready, there are tools to be used, such as vernier calipers, micrometers, steel tape measure and pins, etc..

    2. Process preparation

    (1) To be very familiar with and understand its relevant drawings, and its process requirements, as well as the size requirements, and so on.

    (2) To check whether the material is in line with the process requirements, as well as the equipment to carry out the necessary lubrication work, so that it can work normally.

 

 

Translated with www.DeepL.com/Translator (free version)